Smart codes and tips, tricks of nokia

To check the IMEI (International Mobile Equipment Identity)
Type- *#06# Information you get from the IMEI- XXXXXX XX XXXXXX X TAC FAC SNR SP
TAC = Type approval code
FAC = Final assembly code
SNR = Serial numbe
r SP = Spare


To check the phones Software revision type- *#0000#
Information you get from the Software revision- V 05.31 18-02-99 NSE-3 1ST Line = Software revision
2ND Line = The date of the software release
3RD Line = Phone type


To enter the service menu type- *#92702689# (*#WAR0ANTY#)
Serial number (IMEI) Production date (MM/YY) Purchase date (MM/YY) You can only enter the date once. Date of last repair
(0000=No repair) Transfer user data to another Nokia phone via Infra-Red.

Clock Stopping
To check weather your SIM Card supports clock stopping type- *#746025625# (*#SIM0CLOCK#)


Revealing the Headphone and Car-Kit menus
Please note that if you do these next tricks, the new menus can't be erased without retoring the factory default settings. To do these tricks you need to short-circuit the pins on the bottom of the phone next to where you plug in you charger. 1. To activate the "Headset" menu, you need to short- circuit pins "3" and "4". After a short time the word "Headset" will be shown in the display. Menu 3-6 is now enabled.
2. To activate the "Car" menu, you need to short- circuit pins "4" and "5". After a short time the word "Car" will be shown in the display. Menu 3-7 is now enabled.


THE REBOOT TRICK
This should work on all software versions of the 6110.
1. Go to the Calendar (Menu- 2. Make a note or reminder. 3. Enter some text into the edit box. 4. Hold "Clear" until the whole text is cleared, then press "Back". 5. Press "0". The main screen will now be showing but a space appears on the screen. (you can't see it) 6. Enter 4 digits (e.g. 1234). 7. Use the down arrow to move the cursor to the left side of the numbers and the space (Down arrow twice). 8. Now enter 6 digits and press the call button. Wait for a few seconds, the
screen should start to flash and reboots. It should alsowork on other menus like the "Profiles" menu.

NETWORK MONITOR There is a hidden menu inside your Nokia phone. If you want to activate it, you'll have to re-program some chips inside of your phone. 1. Check your software version. You can only continue if you have v4.33, v4.73 or v5.24. 2. Take apart the phone. 3. De-solder the EEPROM (ATMEL AT 24C64). 4. Read out the data with an EEPROM programmer and save it to a file (Backup). 5. If you have v.33 or v4.73, change the address "03B8" from "00" to "FF". 6. If you have v5.24 then change the address "0378" from "00" to "FF". 7. Write the new data to the EEPROM and solder it back to the phone, 8. Power on your phone and you should have "Netmonitor" enabled. The Network Monitor gives you the following information. Carrier number MS RX Level in DBM Received signal quality MS TX power level C1 (Path loss criterion, used for cell selection and reselection). The range is -99 to 99. RTL (Radio link timeout). Timeslot Indication of the transmitter status Information on the Network parameters. TMSI (Temporary Mobile Subscriber Identity). Cell identification (Cell ID, Number of cells being used). MCC (Mobile country code) MCN (Mobile network code) LAC (Location area code) Ciphering (On/Off) Hopping (On/Off) DTX (On/Off) Discard cell barred information.


SIM-LOCK CHECKS
#PW+1234567890+1# = GIVES PROVIDER-LOCK STATUS
#PW+1234567890+2# = GIVES NETWORK-LOCK STATUS
#PW+1234567890+3# = GIVES COUNTRY-LOCK STATUS
#PW+1234567890+4# = GIVES SIM-CARD-LOCK STATUS.